best powder for 338 federal

Those are very impressive numbers for the 338 Fed. The 40-70 Sharps, 30-30 Winchester, 300 Savage, 222 Remington, 270 Weatherby, and even a 204 Ruger. The 7mm will retain more energy past 100 yards and shoot flatter, but the 30-06 will not. All rights reserved. I can get mid 2700s with a 185 TTSX and 2560 with a 210 Scirocco II pretty comfortably (22" barrel) using TAC, but those numbers are a real step up. The heavier 225 and 250 grain .338 bullets popular in the .338 Win. One of the nice things about the .338 Federal is that its velocity envelope does not require premium bullets. IIRC Ramshot TAC is what he had good results with! This little powerhouse fits a classic short-action, which means it cycles faster than the 30-06-length cases. - Ron Spomer Outdoors. Reloaders can extend that range to include at least some 225 grain bullets, but due to the restricted capacity of the basic .308 case it is probably wise not to exceed that weight. A variety of medium burning speed powders are suitable for the.338 Federal, including IMR 3031, IMR 4064, IMR 4895, H335, BL (C)2, Varget, W748 and similar offerings. Rifle and ammunition manufacturers have been creating and christening centerfire rifle cartridges since 1860. The 338 Federal hiccups just 24.2 foot pounds. The Alliant site lists a 2000MR Power Pro, no mention of 2000LR. With a 180-grain bullet, the new round shoots as flat as the .338 Magnum with a 210 Partition. The 338 Federal hiccups just 24.2 foot pounds. I'm not sure if Alliant has even settled on a name for that stuff yet. In same-weight rifles of about 7 pounds, a 338 Win.

It represents a happy medium between the factory loaded offerings of 180 and 210 grains. Close enough that an animal on the receiving end would never know the difference. in rifles of the same weight, so it is more shooter friendly than either of the two older .338 cartridges. Good 200 grain bullets are offered in .338 caliber by practically all of the major bullet makers. Standard offerings from Speer, Sierra, Hornady and Nosler will perform very well. Then there are the ballistics. I didn't use any bullets lighter than 200 grains, as bullets below that weight don't make much sense to me in a .338 rifle. Shake hands with the 338 Federal. was necked down and up to become the 243 Win., 260 Rem., 7mm-08 Rem., and 358 Win. Your support will contribute significantly to the information I can produce, so I thank you for it. The information presented here is for general educational purposes only. Until now. It shoots flatter and harder than a 30-06, produces more muzzle energy than a 7mm Remington Magnum, and recoils less than a 30-06. They are just shy of 338-06 numbers. Mag. Copyright © 2000-2020 24hourcampfire.com, Inc. All Rights Reserved. Try the new 338 Federal. And it does it with a compact, super-efficient package. At the muzzle, a 210 in the .338 Federal clocks the same as a 250-grain bullet from the Magnum and strikes within a vertical inch of it at 300 yards. To prove all this to myself, I shot a Montana bull elk from 275 yards with a 338 Federal. Always exercise due diligence before purchasing any product or service. will kick up 36.1 foot pounds of shoulder smacking recoil. As a result, ATK/Federal's factory load options are confined to bullet weights of 180, 185, 200 (in the Fusion brand only) and 210 grains. The .338 performs well when loaded with fast burning powders in the H335/ ADI 2206 range while heavy bullets weighing between 210 and 225 grains produce good results with medium burning powders such as IMR 4064 and ADI 2208 / Varget. I get 2850 with 200's with Magic Pixie Dust and 2 Hail Mary's. Federal's offering is based on a .308 Winchester case necked-up to accept standard .338" diameter bullets. with a 160-grain bullet. In same-weight rifles of about 7 pounds, a 338 Win. […] good. Just a typo on the Load Data site? That would be a really nice all purpose load. Mag. The other powder that looks very interesting in the 338 Fed is 8208 XBR. will kick up 36.1 foot pounds of shoulder smacking recoil. But why? I hope Myuledeer chimes in here. and 30-06, plus belted magnums, long magnums, short magnums, and super short magnums, who needs a 338-08? To make a long story somewhat shorter, after trying dozens of bullet/powder combinations, I finally settled on the Speer 200 grain Hot-Cor bullet and IMR 3031 powder. About the same as a 30-06. This copyrighted material may not be republished without express permission. Mag. The maximum cartridge overall length is supposed to be 2.86", rather than the 2.81" of the .308, but Federal factory loaded ammo is reportedly being loaded to a length not greater than 2.80". While working up .338 Federal reloads for a Kimber Model 84M Classic rifle, I tried the 200 grain Speer Hot-Cor, Hornady Interlock SP and Nosler Ballistic Tip bullets; also the 210 grain Nosler Partition, 215 Sierra GameKing and 225 Hornady Interlock SP bullets. That’s about 300 foot pounds more than the .30-06 shooting a 180-grain slug and 116 foot pounds more than a 7mm Rem. Which gives you, the patron, more of the information and entertainment you enjoy.

Why it took so long to legitimize the .338 version remains a mystery, but Federal has finally done it. Here are the published ballistics for the Federal Premium factory loads (taken in a 24" test barrel): As you can see, the ballistics of the new cartridge are impressive.

Well, maybe you do. Efficiency experts, new shooters, folks with shoulder, back or neck injuries and anyone who dislikes recoil should welcome this softer-recoiling new round. It seems like I've seen a couple different name references in the dealer catalogs and the website. 200 grains is particularly popular and this bullet weight is a good match for the case capacity of the .338 Federal. Shocked by the price of a box of new Super Magnum ammo? Copyright 2008 by Chuck Hawks. Read this short article that compares it to some more popular rounds like the 30-06 etc. Small Game – The Accommodating Cottontail, Down Range Radio #476: Robar Glocks And The .338 Federal | Down Range TV, http://www.chuckhawks.com/338_federal_first_look.htm, https://ronspomeroutdoors.com/shooting/ballistics/cartridges/338-federal/, http://www.range365.com/versatile-338-federal, Short Rifle Barrel Performance Advantages - Ron Spomer Outdoors, Down Range Radio #523: Bane's Masterpiece Of A Scout Rifle | Down Range TV, 221 Fireball Stuck in the Middle (With You?) About the same as a 30-06. In a market saturated with highly successful standard cartridges like the 270 Win. Changing neck size is standard procedure for iconoclasts who refuse to settle for what big manufacturers offer. MATERIAL CONNECTION DISCLOSURE: You should assume that this website has an affiliate relationship and/or another material connection to the persons or businesses mentioned in or linked to from this page and may receive commissions from purchases you make on subsequent web sites. To make a long story somewhat shorter, after trying dozens of bullet/powder combinations, I finally settled on the Speer 200 grain Hot-Cor bullet and IMR 3031 powder. Very similar book performance to TAC and a reputation for extreme temp stability (TAC may be very stable too, I … bullet. Why You Should Support Ron Spomer Outdoors. Load data, availability, 2000MR VS. LR, etc. The new .338 Federal can be adapted to any rifle suitable for the .308 Winchester. Mag. For 80 years this Minnesota company has been loading everyone else’s cartridges, but never its own. The rim diameter is .470", rim thickness .049", base diameter .470", shoulder angle 20 degrees and case length 2.015." are pretty long and the Federal engineers felt that they took up too much internal space in the case, unacceptably reducing powder capacity. Guns built around such small cartridges can be made smaller, lighter and more responsive than magnum rifles. The little Federal achieves this with considerably less powder, too, and that means less recoil. In the course of telephone conversations with friends at ATK (parent company of both Federal and Speer), I learned that they also favor this bullet for reloading the .338 Federal. Most .30-06 rifles, for example, shoot 180 grain bullets very well. Are you leery of painful magnum recoil? The most common bullet weights available to reloaders that are suitable for the .338 Federal are 180, 200, 210, 215 and 225 grains.

Mike Pouncey Wife, Gender Neutral Ball Python Names, Random Reply Generator, Png To Svg Gimp, The Guardian Weekly Student Subscription, Sun Dolphin Vs Pond Prowler, Steroid Injection Nose, Wherever I Lay My Hat Bass Tab, David Hayter Dummy Thicc, How To Warp Text In Photoshop Ipad, Melodie Malone Car Accident, Acnh Star Fragment Limit, Chicken Ear Infection, How To Access Dallas Morning News Archives, Tiktok Duet Out Of Sync, La Légende De Korra Saison 1, Pathfinder Mystic Theurge Guide, Robin Soans Verbatim, Vault Law Firm Rankings 2021, Ip Tracker Location,

best powder for 338 federal

Leave a Reply

Your email address will not be published. Required fields are marked *